JET RULER is very pleased to announce the production of what is one of aviations most epic aircraft ever, the General Dynamics F16 Fighting Falcon.
This 1/6 scale version has been designed with an improved wing area, to provide better performance and flight characteristics.
SPECIFICATIONS:
Model: 1/6 F16
Wingspan: 1640mm
Length: 2470mm – Plus pitot tube
Weight: 17kg
BASIC SETUP:
Control throws:
Aileron: 25 degrees up / 25 degrees down – 40% Expo
Measured from the wingtip
Rudder: 30 degrees left / 30 degrees right – 30% Expo
Elevator: 25 degrees / 25 degrees – 40% Expo
Measured from the front of the leading edge of the elevator.
The CG is 230mm from the front leading edge on the root of the wing (Factory Settings)
FEATURES:
Full composite construction, lightweight and strong
Painted outside the mold so no seam lines
Easily detachable ventral fins, helps in place with just two screws
INCLUDED HARDWARE:
Complete air frame (including fibreglass control horns)
Carbon fibre wing-tubes
Servo extension leads
Fixed Dual wall thrust pipe (for 160-240N turbines)
Fuel tank (5300ml)
Pre-prepared pushrods with ball links
Pre-glued control horns
JP electric retract gear with brake
OPTIONAL EXTRAS:
Simulate fighter cockpit
Light system
PNP and installation service
REQUIRED HARDWARE:
Turbine: 160-240N
Servos: x9
x4 middle size servo, 12-20kg)
x5 standard size servo, 30-40kg
Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.
PNP version
(Accs., Servos and Linkages pre-installed) 5.3L fuel tank,UAT, fuel tank exhaust port, servo extension leads, hardware, tail nozzle, Electric retracts with controller, Brake controller, pre-installed lights with controller plus extra free scale cockpit, scale jet pilot, missiles, wing bags, and maintenance stand.
